Self-adhesive sandblast film for windows is used to achieve privacy. With this film, you will only see shadows from whichever side you look at. The film applies to glass, allowing natural light to pass through while limiting solar radiation.

• Self-adhesive
• Transparent
• Material - PVC
• Roll width - 105 cm

The films can be applied to mirrors or plexiglass: windows, glass doors, shower cabins. Installation can be done in areas with a minimum temperature of 15 degrees Celsius.

Steps for applying the film with water:

• Clean and degrease the glass.
• Prepare the application solution by mixing 1 liter of water with 1 teaspoon of liquid dish detergent or shampoo.
• Cut the piece of film you need for the window, leaving a margin of 2-3 cm.
• Peel off the protective sheet from the back of the film, spray the solution on the back side of the film as you peel off the sheet.
• Spray the solution on the window, then gently adjust the film and make the necessary adjustments. Start removing water and air from the center towards the edges. Using a sharp cutter, cut off the excess material next to the mirror.

After application, white spots may appear under the film. These represent a reaction of the adhesive with water and will disappear once it dries. The adhesive will dry completely in about 1 week.