The adhesive film with sandblasting is used for privacy, as you will only see shadows from any side you look at. The film is applied to glass, allowing natural light to pass through while blocking direct sunlight.

• Adhesive
• Transparent
• Material - PVC
• Roll width - 137 cm

Instructions for applying sandblasting film:

• The film can be applied to mirrors or plexiglass such as windows, glass doors, shower cabins. Installation can be done in spaces with a minimum temperature of 15 degrees Celsius.
• Steps for applying film with water (required materials: window cleaning solution, water, liquid detergent/shampoo, spray, spatula, cutter, cloth):
• Clean and degrease the glass.
• Prepare the application solution by mixing 1 liter of water with 1 teaspoon of liquid detergent or shampoo.
• Cut the piece of film you need for the window, leaving a margin of 2-3 cm.
• Remove the protective sheet from the back of the film and spray the solution on the back of the film while keeping the protective sheet. This way, the film will not attract dust.
• Spray the solution on the window, then carefully apply the film and make the necessary adjustments. Start pushing from the center to the edges to remove water and air bubbles. Using a well-sharpened cutter, trim off the excess material next to the frame.

After application, white spots/stains may appear under the film. These represent a reaction of the glue with water and will disappear once they dry. The glue will dry completely in about 1 week.