K2 DPF Cleaner is designed to clean diesel particulate filters. Its concentrated formula dissolves soot and ash deposits without requiring the filter to be removed. It can help restore engine performance and responsiveness, reduce fuel consumption, and extend the filter’s service life.
Before use, the engine must be cold, below 50 °C. Remove the exhaust gas temperature or pressure sensor, then spray the product into the filter through the opening, pausing for 3–5 seconds between sprays. Reinstall the sensor and let the engine idle for at least 15 minutes. Then drive for approximately 30 minutes, preferably outside the city, keeping the engine speed between 2,500 and 3,000 rpm. In some cases, DPF regeneration using diagnostic equipment may be required.
- Type: DPF filter cleaning spray
- Quantity: 500 ml
- Cleaning action: Dissolves soot and ash deposits
- Filter removal: Not required
- Engine preparation: Below 50 °C
- Idling time: At least 15 minutes
- Driving time: Approximately 30 minutes
- Engine speed: 2,500–3,000 rpm
- Product Number
- K2-00962
Specifications
- Type
- Cleanser
- With Straw
- No
Capacity
- Quantity (ml)
- 500 ml
Important information
Specifications are collected from official manufacturer websites. Please verify the specifications before proceeding with your final purchase. If you notice any problem you can report it here.