AQUAFOREST BALLING COMPONENT +1, +2, +3 3X5000ml

The chemical composition of the Component 1+2+3+ formula is based on the H. Balling method but has been modified and enriched with trace elements essential for the proper functioning of a marine aquarium. Thus, 3 liquids are produced which, when dosed regularly in equal amounts, meet the needs of corals not only in magnesium and calcium but also in all elements whose doses are difficult to determine under home conditions and require attention and consistency in dosing. Maintaining appropriate levels of magnesium and calcium allows the correct amount of trace elements in a reef aquarium (Ca 380-460 ppm, Mg 1180-1460 ppm).

Dosage:

It is recommended to administer all liquids in equal amounts, which should be determined and adjusted based on coral consumption. Testing the basic water parameters is advised: Calcium, Magnesium, and Carbonate Hardness (KH). If the consumption of any element is higher, it is recommended to dissolve an additional solution (Calcium, Magnesium, or KH Buffer) and dose this solution separately until the parameters are balanced.

For a moderately stocked hard coral aquarium, the dose is approximately 25 ml daily per 100 liters of water.

• Component 1+ contains: Ca, Sr, Ba, Co, Mn, Cu, Fe, Zn, Ni, Cr. (25 ml increases Ca by 4.5 ppm / 100L)
• Component 2+ contains: NaHCO3, F, I (25 ml increases KH by 0.65 dKH - Alk 0.23 meq / 100L)
• Component 3+ contains: Mg, inorganic salts, and K, B (25 ml increases Mg by 0.38 ppm / 100L)

Component 3 contains Reef Mineral Salt, a product essential for the proper stabilization of parameters in the aquarium.