The basic prerequisite for achieving good results is thorough preparation. Surfaces must be clean, dry, and free from defective or poorly adhering materials, dust, oils, and salts.

New metal surfaces:
Degrease the surface using Thinner 120. Prime with X-RUST, 2 coats

Painted metal surfaces:
Sand the surface lightly. Prime with X-RUST, 2 coats

• Mix component A thoroughly before use, and once homogeneous, gradually add component B while continuously stirring.
• Apply ensuring enough paint is used to cover an entire section. This practice is important to achieve a perfect result.
• Before application, surfaces are smoothed with appropriate sandpaper.
• To avoid bubbles during application, perform the work in the shade as much as possible.
• Do not apply when the air and surface temperatures are below 10°C or above 35°C, nor when the relative humidity exceeds 70%.
• Good ventilation of the area is required during application due to hazardous fumes.
• After the X-RUST dries, sand the surface, remove dust, and apply the two-component polyurethane coating system of your choice (POLYGLOSS, ANTISKID, MONOTRETEN) or one of the topcoats from the TROPIKAL series.

• The ambient temperature and the thickness of the coating determine the drying time.
• Surface drying: 1 hour.
• Re-coating time: 2-4 hours.
• Coverage: 10-14m²/liter, depending on the thickness of each coat and the absorbency of the surface.