Category: Heating Elements

• Power supply: 230V/50Hz
• Power: 200W-1000W
• Operating temperature: 0 - 55℃
• Temperature adjustment range: 30 – 70℃ (5℃ setting)
• Operating modes: Standby / with water temperature setting 2H/4H/6H/8H timer
• Memory function
• Insulation class: Class I
• Waterproof rating: IPX4

Installation instructions:

• The device should not be screwed or unscrewed from the plastic part.
• The device should not be placed horizontally or facing downward.
• Do not fill the radiator body up to the top edge with water as swelling will occur once the temperature rises.
• Water with antifreeze or the correct type of oil can be used as a heat transfer medium.
• The radiator body should be heated only by the heating element.

Warning: Do not install the heating element parallel to the heating system.

Electric heating element:

• The device should not be connected to power during installation.
• Place the heating element in the lower inlet of the radiator body.
• Tighten the electric heating element to the radiator body by turning its base with a size 22 wrench.
• Make sure the connection between the heating element and the radiator body is tightly secured.

Uninstallation:

• If the radiator body is already installed in the central heating system, close the valves and remove any fluid inside it before installing the electric heating element; the radiator body may need to be flushed to clean out existing sludge and metallic deposits.