Surface Preparation for Anti-Mold Hydrocolor

• To ensure proper adhesion of the product, the surface to be painted must be cleaned of dust, greases, oils, peeling old paints, rust, mold residues, or moisture.
• For new or porous surfaces, first apply the corresponding recommended primer of the product.
• Apply the product in 2 coats, allowing 1 - 2 hours between each coat.

Application Conditions for Anti-Mold Hydrocolor

• Avoid applying the product at temperatures below 6°C and above 40°C, and when relative humidity is greater than 80%.
• Adverse conditions during application can alter the final properties of the paint.

Application Tools

• Brush
• Roller
• Spray gun

During work, keep tools “wet” inside the container. Thoroughly drain the product from the tools and clean immediately with warm water and soap. If the product dries, it can only be removed with strong detergents. Do not dispose of washing liquids into the groundwater.

Warning: Wear protective gloves, protective clothing, and personal protective equipment for the eyes and face. In case of contact with eyes, rinse carefully with plenty of water for several minutes. If contact lenses are present, remove them if easy to do so. Continue rinsing.