Set consisting of 4 wireless sound signals SG-K2 and one receiver.

Features of the Baracuda SG-K2 Wireless Sound Signal Set + Receiver:

• 3-function switch (top night mode, middle mute, bottom daytime mode)
• Reset button R (pressing R stops all functions for 20 seconds; after this time, all functions return to the default settings)
• Memory function (even if the battery is removed, all settings are saved for the next use)
• Different detection for backfall
• Night brightness selection with diode for low battery consumption
• Vibration or silence selection on the receiver
• Automatic detection system for synchronization with the sound signals and the receiver
• Two detachable rods for alerts for each sound signal
• Extremely bright, high-quality LEDs with long lifespan
• Compact design
• Long range (100-150m, depending on usage conditions)
• Low power consumption and battery discharge indicator
• Adjustable sensitivity, volume, and tone
• Recognizable A.B.S. casing with pleasant finishes
• Installed electronic circuits
• Durable speaker and components
• Jack for hanger or swinger
• The receiver operates with 3 AAA batteries, while the sound signals use one 9V battery

Instructions for Use:

• Open the battery cover of the receiver. Install the 3 AAA batteries.
• Turn on the receiver by rotating the V knob (to turn off the receiver, rotate in the opposite direction).
• Open the battery cover of the sound signal to install the 9V battery.
• Turn on the sound signal using the 3-function switch located at the bottom.
• Adjust the volume by pressing the V button, the sensitivity by pressing the S button, and the tone by repeatedly pressing the T button until the desired setting is achieved.
• Pressing R will stop all functions for 20 seconds; after this time, all functions return to the default settings.

Synchronization Instructions:

• Turn on the sound signal and the receiver.
• Press and hold the button on the back of the receiver.
• Turn on the sound signal by rotating the magnetic wheel.
• The receiver will emit a sound signal, simultaneously with a warning light. This indicates that the synchronization process has been completed.

Warning! Although the sound signals are designed to work in any weather conditions, do not submerge them in water! If you do not use the sound signal or the receiver for a long time, it is recommended to remove the batteries. Do not tighten the sound signals excessively onto the bases to prevent potential malfunctions. Although the signal range of the sound signals is very large, it is suggested to stay close to the rods.