Camera sill in stainless steel compatible with VW CRAFTER from 2017 onwards.
Product Features:
- Custom design precisely cut with recognized laser technology.
- Glossy finish.
- Most parts are easily installed with double-sided adhesive tape (pre-installed).
- Guaranteed not to rust.
Installation Instructions:
- Installation should be done in a dry and clean environment.
- Before installation, test the area where the products will be applied without removing the pre-installed double-sided tape.
- The surface where the product will be adhered must be clean and free of greasy substances.
- Avoid cleaning with additives and greasy substances!
- Preheat the area where the product will be placed.
- Attention! Do not install at temperatures below 15 degrees Celsius.
- Apply the product immediately after cleaning and preheating, removing the protective film from the adhesive tape.
- After application, press with a cloth to ensure good adhesion.
- Ensure no water enters the area where the installation was performed for 24 hours.
Note: Installation instructions are not included in the package!
Suggestions:
- For better and long-lasting adhesion, it is recommended to additionally use double-sided adhesive tape or automotive silicone.
- Volkswagen
- Crafter
Important information
Specifications are collected from official manufacturer websites. Please verify the specifications before proceeding with your final purchase. If you notice any problem you can report it here.